Fender Passport Manual De Instrucciones página 11

Scanning for a clear channel:
There are 16 channels available. The receiver will scan through the channels
in the following order:
To scan for a clear channel:
1. Press and hold the SCAN (A) button on the receiver module for 1
second.
2. The receiver module will automatically scan the channels and switch to
the first available clear channel. The new channel will be shown on the
CHANNEL indicator (B).
Note: If the current channel is clear, the receiver will not change channels. The
channel number shown in the CHANNEL indicator will remain the same, but it
will blink for 5 seconds to acknowledge that a scan was completed.
Manually forcing a channel change:
To manually force a channel change, press the SCAN (A) button a second
time while the CHANNEL indicator (B) is blinking. This will force the receiver
to change to the next available clear channel.
Programming the transmitter:
To program the UHF handheld wireless microphone or the UHF belt-pack
transmitter:
1. Make sure the transmitter is on, then point the HOT SPOT on the
transmitter at the HOT SPOT (F) on the receiver module.
Note: The HOT SPOT is located on the end cap of the UHF Handheld wireless
microphone, and on the battery cover of the UHF Belt-pack transmitter.
2. Press the PROGRAM MIC button (E) on the receiver module.
During programming, the CHANNEL indicator on the receiver module will
blink and the LED on the transmitter will light up.
When programming is complete (usually about 1 second), the CHANNEL
indicator will stop blinking and the LED on the transmitter will go dark. The
transmitter is now set to the new channel.