Preliminary Check; Hot Water - Sanremo AMALFI 2GR SED Libro De Instrucciones

ENGLISH
components, since it removes scale and residues from the water that would otherwise shorten their life.
The company is relieved of all and any liability in the event of failure to comply with the
above instructions.
Before using the appliance, check that:
- the plug is inserted properly into the mains power outlet;
- the water fi lling hose is correctly connected to the mains water outlet, check for leaks and that the water
tap is open;
- the drain pipe is positioned in accordance with the preceding instructions.
With a steam tap (B) open, put the on/off switch (D) to position 1 and wait for the water in the boiler to
reach the maximum level set by the electronic control. If the boiler does not fi ll within the set time-out
(90 sec.), the pump stops and the indicator lights on the keypad start to blink. In this case put the on/off
switch (D) to position 0 and then to position 1 to fi nish fi lling the boiler.
Now put the on/off switch (D) to position 2 so that the heating elements are powered and therefore start
to heat the water.
Wait for steam to come out the steam nozzle (B), then close the tap and, using the Boiler pressure
gauge, check that the pressure has reached and maintains a value of 0.8:1 bar. If it is not on this value,
turn the adjusting screw on the pressure switch (+increase, - decrease, see fi gure below).
Ensure that the boiler pressure gauge indicates a pressure of 0.5:1 bar. Turn the tap knob (C) counter-
clockwise. Pay the utmost attention in order to prevent scald burns.
There are two steam nozzles at the sides of the work surface. These steam nozzles are retractable and
swivelling as they are fi tted with a ball joint. To discharge steam, turn the knobs (B) anticlockwise. Pay
the utmost attention in order to prevent scald burns.
Insert the fi lter holder (E) into the group head (F) turning the fi lter holder counter-clockwise. Select the type
of dispensing required on the keypad (M):
M1=One strong/normal coffee.
M2=One normal/weak coffee.
M3=Two strong/normal coffees.
M4=Two normal/weak coffees.
M5=Electronic programming key or continuous manual dispensing.
USE

Preliminary check

Pressure switch parts:
1 - Ring
2 – Membrane unit
3 – Tefl on membrane
4 - Nut
5 – Disk with pipe tap
6 - Grommet
7 - Screw

Hot water

Steam
Coffee with Mod. AMALFI SED
17