Schmelter UVCARE midi Instrucciones De Uso página 4

Please read the entire instructions for use carefully, as they contain
important information for safe operation. This product is freely
available. To achieve the best possible success, however, it must be
operated correctly and the safety regulations applied.
- Keep the instructions for use. Perhaps want to read it again later.
- Ask the seller or the manufacturer if you have more need
information or advice.
- At the end of the life of the UVC light source, it must be yours
security to be exchanged. The lamp is properly to dispose.
This leaflet includes
1. What is UVCARE® and what is it used for
2. What do you have to do before installing UVCARE®
note
3. How is UVCARE® to be installed
4. What are the risks of UVCARE®?
5. How long can UVCARE® be operated?
6. Are there any side effects when using the UVCARE®
7. More information
1. What is UVCARE® and what is it used for?
This product is used to decontaminate the room air, which
can be contaminated by viruses, bacteria or fungi,
including those enclosed in aerosols. It can reduce the
virus load in polluted rooms by up to 99.9%, whereby the
type of virus determines the application time. Flu viruses,
coronaviruses, viruses of almost all other infectious
diseases, fungal spores, etc. can be inactivated. It can be
assumed that mutations of known strains in your DNA will
also be attacked and will no longer be able to replicate
after exposure to radiation.
2. What do you have to consider before installing
UVCARE®?
UVCARE® may only be used indoors. Before drilling the
mounting screws, make sure that there are no power
cables. Connect the device by inserting the Euro plug into a
suitable socket.
The on / off switch for the device is also located on the
device plug.
Instructions for use
3. How is UVCARE® to be installed?
The most optimal installation is the suspension from the
ceiling, followed by the horizontal wall installation, the
vertical wall installation and the standing installation.
The ceiling suspension:
Screw the supplied support plates under the ceiling. Pay
attention to a tight fit! Screw in the retaining screw for the
wire rope. Insert the rope into the rope holder on one side
and then screw it into the center of the cross holder
(screw). Then thread the wire rope into the ceiling rope
post and align it. Repeat these steps for the second
bracket. The rope can be released again by pressing the
outer ring of the rope holder. Hang the UVCARE® just
above head height in order to achieve an optimal
disinfection result.
The wall suspension:
Fix the screws horizontally or vertically in the wall at the
appropriate distance from the cross bracket. Hang in the
UVCARE®. The horizontal installation at head height gives
a better result than the vertical installation. For reasons of
design or space, the UVCARE® can also be installed
vertically (perpendicular).
The stand installation:
The UVCARE® can also be installed as a portable stand
solution with the help of optionally available feet. In this
case you need an air intake plate with retaining screws
and corresponding feet (M8 external thread - at least
80mm).
4. What are the risks of UVCARE®?
UVCARE® has a light source inside that emits extremely
strong UV radiation. This radiation is encapsulated inside
and cannot penetrate through the lamellar openings
(intake - exhaust) to the outside. Since the UV rays can
damage the retina as well as cells of the skin, the product
must no longer be used, regardless of how damaged.
When replacing the lamp, make sure that the power
supply is only switched on after the UVCARE® has been
completely closed.
We recommend having the light source exchange carried
out by a specialist or in the production plant. This only has
to take place after an operating time of 9000 hours
(approx. One year of continuous operation). Do not use
the product after the maximum light source duration has