Shutting Down; Settings - Accu turn 1500 Manual Para El Operador

32
Operations
- switch the balancer on again.
• Carefully repeat the commands with the manual at
• Carefully repeat the commands with the manual at
hand.
• Call Accu Service immediately if the unit does not
hand.
• Call Technical Service immediately if the unit does
operate correctly:
not operate correctly:
WARNING: DO NOT ATTEMPT TO USE THE
WARNING: DO NOT ATTEMPT TO USE THE BALANCER IF START-UP SELF TEST IS NOT
BALANCER IF START-UP SELF TEST IS NOT SUCCESSFUL.
SUCCESSFUL.
5.2.3

Shutting down.

5.2.3 Shutting down.
Always shut down properly at the end of a work shift:
• Remove the wheel from the balancer.
Always shut down properly at the end of a work shift:
• Remove the cones and quick-release wing nut from • Remove the wheel from the balancer.
• Remove the cones and quick-release wing nut from
the stub shaft. Check the surfaces (internal and
the stub shaft. Check the surfaces (internal and external) of the cones for damage. The cone is very
external) of the cones for damage. The cone is very important for a good balance quality.
• Check the thread of the quick-release wing nut.
important for a good balance quality.
• Check the thread of the quick-release wing nut. • Clean all threads and surfaces with a dry, soft cloth.
• Clean all threads and surfaces with a dry, soft cloth. • Store the cones and the quick-release wing nut in
• Store the cones and the quick-release wing nut in
the correct place.
• Unplug the power cord from the power outlet.
the correct place.
• Unplug the power cord from the power outlet. • Check the power cord for damage or wear.
• Check the power cord for damage or wear.
• Clean up the weight storage areas.
• Clean up the weight storage areas. • Clean the display and control panel with a soft, dry
• Clean the display and control panel with a soft, dry
cloth.
• Remove old wheel weights and other material from
cloth.
• Remove old wheel weights and other material from
under the balancer. The balancer must rest stably
under the balancer. The balancer must rest stably on on its three feet only.
its three feet only.
5.2.4

Settings.

5.2.4 Settings.
When you switch on the unit, a balancing weight
positioning mode is automatically shown. If the unit When you switch on the unit, a balancing weight
comes up with a balancing weight application mode positioning mode is automatically shown. If the unit
different to the one you want, refer to Chapter 5.3.2. comes up with a balancing weight application mode
different to the one you want, refer to Chapter 5.3.2.
When the machine comes on, the measurement units
displayed are those active when the machine was last At power up, the units of measurement are ounces for
weight imbalance and inches for wheel parameters. turned off. To modify the measurement units refer to
Chapters 5.4.3 and 5.4.4.
Operator's Manual ACCU 1500