EINHELL EX 115 Manual De Instrucciones página 7

Anleitung EX 115 -12sprachig
Important!
Please make sure the machine is switched off before removing
the plug from the socket.
The eccentric sander is not suitable for wet sanding.
If you use a cable reel, the complete cable must be drawn off the reel.
(The conductor must have a minimum cross section of 1 mm
Always remove the plug from the socket immediately after use.
Keep the power cable safe from damage. Oil and acid can cause
damage to the cable.
Never carry the machine by its power cable.
Never remove the plug from the socket by pulling on the power cable.
If you discover any damage to the machine, seek professional help
from a specialist workshop.
Switching on and off
To switch on: Press On/Off switch A.
To operate: Secure switch A with the lock button B.
To switch off: Press On/Off switch A.
The machine can be operated either intermittently or continuously.
Important!
Wear goggles and a dust mask.
Keep the cooling vents on the motor housing clean and
unobstructed at all times.
To be able to make the best use of the eccentric sander,
always use original Einhell spare parts and accessories,
available from all specialist retailers.
Fitting the sanding disk
Easy disc replacement thanks to Velcro-type backing. Make sure the
apertures in the disk coincide with those in the backing pad.
Replacing the carbon brushes
Remove the housing part (A)
Replace the brushes (B)
Replacing the backing pad
Release the 4 screws and then remove and replace the backing pad.
Important!
Damaged backing pads must be replaced immediately. Always
remove the plug from the socket first.
Working with the eccentric sander
The entire sanding surface must rest on the workpiece.
Switch on the machine and, applying moderate pressure, move it
over the workpiece in circular, crosswise or lengthwise
movements.
Use a coarse-grained disk for rough sanding and a fine-grained
disk for fine sanding. The best grain for a particular job is best
ascertained by trial runs.
Important!
Wear a dust mask and goggles. Protective gloves are
recommended. The sander must never be used for work on
materials which contain asbestos.
08.11.2001 11:24 Uhr
2 .)
Seite 7
GB
7