Part 3
Check that the oil drain valve "C" (fig.2) inside the appliance, is
closed.
Introduce the fat, that has previously been melted in another
recipient, or the oil and check that they do not go over the maximum
level; each tub can contain a maximum of 14 litres.
WARNING!
Do not use the appliance without water.
(fig.4)
Press and turn knob "A"
pressed in.
At the same time press ignition button "B" (fig.4) repeatedly to light
the pilot light.
After the flame has lit, hold the knob down for roughly 10 seconds
(count to 20); so the thermocouple heats up and keeps the safety
valve open.
Note: if the piezoelectric device cannot be used, you can light the
flame by hand using a match or a gas lighter.
The food to fry mustn't be too wet. The quantity to be fried must
▪
not exceed 2kg. in weight each load.
Make sure the machine is turned off and the oil is at room
temperature. To empty the tub, use the "V" recipient (fig.2) supplied.
In the case of overheating, due to incorrect use or due to a faulty
component, the safety thermostat "E" (fig.2) is activated. This
automatically cuts of the delivery of gas to the burners. When this
Turning the burner of the appliance on
from position " " to " " keeping it
Recommendations for cooking
Safety Thermostat
Filling the tub
CLOSED
To light the main burner, turn the knob again until it reaches the
desired position.
Pos.
1
°C
85
TURNING THE BURNERS OFF:
Turn the knob from the position it is in to the "
TURNING THE APPLIANCE OFF
Turn the knob to the "
Whilst using the appliance, keep the lid within reach.
▪
▪
Replace the frying oil frequently to avoid the risk of fire.
Emptying the tub
Make sure the recipient is positioned correctly under the drain valve,
turn the handle of valve "C" (fig.2) slowly. Filter the oil or fat if you
wish to use it again.
device is activated, close the gas shut-off cock installed upstream of
the appliance and inform the after-sales service
GB / IE - 4
2
3
4
5
100
115
130
155
" position.
" position.
Use
OPEN
6
7
175
195
5410.260.00