Link The Receiver - GE RAK348R1 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS

LINK THE RECEIVER

The thermostat and receiver will not operate as a system until
they are linked together through the installation process. The
linking process binds one or more receivers to a thermostat
so that they will communicate with each other as a control
system. Up to eight (8) receivers can be linked to a single
thermostat. Until linked, a control receiver will not operate.
Once linked, a control receiver will only respond to its specific
thermostat.
LINK THE THERMOSTAT TO THE RECEIVER
A thermostat and receiver that have been linked will not
interfere with or be affected by any other thermostat or
receiver in adjacent rooms, apartments or neighboring homes.
Linking information is stored in memory—It is not necessary to
re-link a thermostat and receiver if the thermostat batteries are
removed or after a power outage.
If multiple installation teams are installing and linking
thermostats at the same time, coordinate the activity to avoid
the possibility of installers simultaneously attempting to perform
the linking process. Because this is an RF system, installers in
nearby rooms/areas where it is possible RF overlap could exist
run the risk of interfering with each other. Installation and linking
activity going on around a system already installed will not
interfere with it.
continued on next page
15