Important - GE RAK348R1 Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
INSTALL THE RECEIVER
2500, 2800, 3500 and 3800 SERIES
ZONELINE MODELS
5. Route the thermostat
cable from the unit to
the R, GL, GH, B, Y, W
and C terminals on the
receiver and connect
by inserting the wire
tips into the bottom
of the block and
tightening the screws.
NOTE: Leave plenty
of thermostat cable
length to allow routing
to and installation
of the receiver onto
the unit.
6. Turn on power at the main service panel by replacing
the fuse or switching the appropriate circuit breaker to
the ON position.
7. Link the Thermostat to the receiver. See the "Link the
Receiver" section on pages 15 and 16.
IMPORTANT: This step must be performed correctly.
Check the thermostat to make sure it is accurately
transponding to the receiver. If the links were not set
correctly, reset them. See the "Reset the Thermostat"
section in the Owner's Manual.
8. Put the cover back on the thermostat and secure with
its cover screw.
(cont.)
6