Mbps Wireless Access Point Installation; Prepare For Installation - U.S.Robotics R24.0378.00 Guia De Instalacion

22 Mbps Wireless Access Point Installation

Note:
For the most recent installation information, refer to the product Web site at
http://www.usr.com/support. You can also refer to the User Guide on the Installation CD-
ROM for more detailed information.

Prepare for Installation

Make sure your computer is turned on. Type your password if you are prompted to do so.
Note: Your product number is 2249. It is very important that you have your serial number
written down before you install the 22 Mbps Wireless Access Point. You can find your serial
number on the bottom label of the 22 Mbps Wireless Access Point and on the side of the package.
If you ever need to call our Technical Support department, you will need this number to receive
assistance.
Note: Be sure to find out what letter your CD-ROM drives uses before you begin installing
your new product. You will need to know this to properly install your software.
Step One: Install your software
Attention:
You will need to install this software on all the PCs or laptops you plan to wire-
lessly network together.
Insert your U.S. Robotics Installation CD-ROM into your CD-ROM drive.
Note: If the Choose Setup Language window appears, select your preferred language and
click OK.
Note: If your CD-ROM does not automatically launch, click Windows Start, Run, and type
D:\setup (or the appropriate letter of your CD-ROM drive) and click OK.
Some files will be copied to your system, and then you will be asked to read the license agree-
ment. Read the agreement and click Yes.
The Installation CD Graphic User Interface (GUI) will appear on your screen. Click Software.
Click Install Access Point Software. Follow the on-screen instructions and wait for some files to
be copied to your hard drive. A window will appear showing you the files that are being loaded
onto your system. When you are prompted to reboot your computer, select Yes, I want to restart
my computer now and click Finish. After your computer reboots, the program window with the
Configuration Utility icons may appear. Close this window. When the Menu screen of the U.S.
Robotics Installation CD-ROM returns, close it.
Remove the Installation CD-ROM and prepare to install your hardware.
1