U.S.Robotics R24.0378.00 Guia De Instalacion página 8

I am unable to enter the 22 Mbps Wireless Access Point Web Configurator.
Possible Solution:
Be certain that you are entering the correct user name (if there is one) and password. The pass-
word field is case-sensitive. There is no default user name or password.
My 22 Mbps Wireless Access Point is not appearing in the list when I scan
for it.
Possible Solution:
You may be on a computer that is physically too far away from the 22 Mbps Wireless Access Point.
Try moving closer to the 22 Mbps Wireless Access Point and repeating the scan procedure. Check
any physical connections between the 22 Mbps Wireless Access Point and your modem, router,
hub, LAN, or switch.
My computer is not acknowledging my 22 Mbps Wireless Access Point.
Possible Solution:
Be certain that the 22 Mbps Wireless Access Point is plugged into a power source and is properly
installed. Make sure the Ethernet cable is securely connected to the Ethernet port on the 22 Mbps
Wireless Access Point and to the Ethernet port on your cable or DSL modem, router, hub, or
bridge.
I am experiencing poor link quality in some areas of my home or office.
Possible Solution:
You might be encountering interference from walls or other structures that is lowering your link
quality. Try placing your 22 Mbps Wireless Access Point at a higher location, such as a higher
shelf, or repositioning it in a different area of your room or office.
I accidentally clicked Cancel during the installation procedure.
Possible Solution:
Remove and reinsert the U.S. Robotics Installation CD-ROM into your CD-ROM drive. Repeat the
installation procedure of the software before you install any hardware.
The installation procedure did not begin when I inserted the Installation
CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from beginning.
Close any open applications and reinsert the Installation CD-ROM.
The 22 Mbps Wireless Access Point is not receiving any power.
Possible Solution:
Make sure the power supply of the 22 Mbps Wireless Access Point is connected to the power jack
on the 22 Mbps Wireless Access Point and to a standard power outlet.
4