Kenmore 116.31200 Manual De Uso Y Cuidado página 22

TO REMOVE CLOG FROM HOSE
1. Rotate the extension hose release lever
counter-clockwise to release extension hose.
2. Remove the upper end of the extension
hose from the wand holder by twisting, and
pulling straight up.
3. Plug in the vacuum cleaner and turn it on.
Extension
Hose --
Wand
Wand
Holder
Release Lever
Nozzle
Hose
4. Stretch the extension hose to maximum
length and then allow the hose to return to
its natural length.
Original
Hose
Storage
Position
-- Hose
5. Re-insert the hose into the original
storage position from which it was removed.
Press firmly to ensure correct placement.
6. Rotate hose release lever clockwise to
the locked position.
If the dust bag, filter areas and the hose
areas are free of clogs, disconnect the
nozzle hose from the wand holder and
check the nozzle for clogging.
Clean the agitator according to the
instructions in the AGITATOR CLEANING
(Page 21)
Return the vacuum cleaner to the upright
position before plugging into an electrical
out Jet.
WARNING
Personal Injury Hazard
DO NOT place hands or feet under-
neath the vacuum cleaner at any time.
TO REMOVE CLOG FROM
CLEAN-OUT PORT
WARNING
Electrlcal Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the vacuum
cleaner. Failure to do so could result in
electrical shock or personal injury from
lhe vacuum cleaner suddenly starting.
1. Using a fiat screwdriver or small coin pry
gently between the cover and the nozzle to
access the clean-out port.
2. Remove any debris or build-up.
Flat
Screwdriver
Clean=Out
Port Cover
3. Reinstall cover. You should hear a notice-
able click when the cover snaps into place.
= 22 =