Technical Data - ALPHA-TOOLS AKP 100 Manual De Instrucciones

Anleitung AKP 100 13.02.2004
Putting into operation Important!
If the power cable is damaged it
Fix the clip-rest onto the front of
must be replaced by the manufac-
the hot glue gun. Fold the clip for-
turer, by the manufacturer's
wards so that it locks securely
Customer Service or by a similar-
into place in the foremost setting
ly qualified person in order to
before inserting the power plug
avoid danger.
into the power outlet.
Always put the hot glue gun down
on a non-flammable surface.

Technical data

Push a glue cartridge into the hot
glue gun as far as the limit stop.
Power supply 110-240 V ~ 50 Hz
Now insert the power plug into the
Power input
power outlet. The glue gun will be
Heat-up time
ready for use after a warm-up
time of approx. 5 minutes.
Melting point
Squeeze the trigger to apply the
Working temperature
glue in drops or strips depending
on which nozzle is used.
Glue stick Ø
Press both surfaces together
immediately. The adhesion time
is approx. 30 seconds.
During interruptions and upon
completing the work, always use
the clip-rest to support the hot
glue gun.
Warnings
Disconnect the power plug
when the device is not in use.
Keep the device away from
children.
Do not let the device come
into contact with water.
The hot nozzle and the hot
glue can cause burns.
If you are going to stop work
for more than 30 minutes, dis-
connect the gun from the
power supply.
Keep inflammable and ignita-
ble materials and objects
away from the hot nozzle.
In the warm-up period and
during use place the hot glue
gun on a non-flammable sur-
face.
Avoid contact with the skin,
water and materials contai-
ning solvents.
Caution!
Glue stains on textiles cannot be
removed
9:26 Uhr Seite 5
GB
15 (50) W
approx. 5 mins
approx. 140°C
approx.
170°C
11 mm
5