Technical Data - tau MFR Guía Para La Instalación

CHARGE REGULATOR
The main technical characteristics of the regulators are as follows:
- control of the battery's maximum charge with charge at a constant voltage;
- control of the battery's discharge;
- block diode incorporated in the regulator;
- display of the battery status by means of two LED (green and red) with fixed or flashing light
based on the operating status;
- extremely high reliability and duration;
- low cost;
- ample terminal board section;
- both input and output protection against pole inversion.
REGULATOR TYPE
Rated voltage
Maximum input current
Maximum output current
Loss
End of charge voltage
Output cut-off voltage
Output reset voltage
Acceptable room temperature
Dimensions
Weight
Connection terminals
PHOTOVOLTAIC
MODULE
MICROLAMP 4A
- +
-
12V BATTERY
8

TECHNICAL DATA

-
+
+
BATTERY INPUT
MFR
N.B. USE LEAD BATTERIES
ONLY!!
To
power regulator, do not use
electrolytic batteries.
CONTROL
UNIT
MICROLAMP 4A
Volts 12
Amps 4
Amps 4
mA 6
Volts 14,3
Volts 11,3
Volts 12,4
°C from -20 to +50
mm 134 x 80 x 29,5
g 150
mm² 6
avoid damaging the