Hotpoint 20 Manual Del Propietario E Instalación página 13

Installation Instructions
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Some models have tile reh-igerator connection at
the end ot tubing located outside the eompr( ssor
compartment a(c( ss cover. On olher models, the
compressor compartlnent access cover musl be
remoxed in order to access the refrigerator
connection at th_ water valve.
c2'
On models using the retrig{ ration connection at
the wal{r valve, remove Ih( plastic tl(xible cap.
©
Place tile COml)ression nut and l'_rrule (sleeve)
onto tile end ot Ill( tubing as shown. On a GE
SmartCommct" Retrigerator Tubing kit, the nuts
are already assembled 1o the tubing.
Ins( rt the end of the tubing into the refrig( rater
connection as lhr as possible. While holding the
tubing, tighlen tile titling.
For plastic tu/)ing fl-om a GE Smarl(](mnect"
Retrigerator Tubing kit, insert th( molded end of
the tubing into the refrigerator comlection and
tight( n the compression mlt until it is hand tight,
then tighten one additional turn with a wrench.
Overtightening may cruise leaks.
Fasten the lubing into lhe clamp pro_ided as
shown to keep it in position. You may ne{d to plT
open tll{ clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Tubing
Clamp
I/4"
Compression
Nut
Tubing
Ferrule
(sleeve)
Sma_Connect TM
Connection Tubing
[] CONNECT THE TUBING TO THE
REFRIGERATOR (CONT.)
Tubing 1/4" 1/4"
Tubing
Ferrule
(sleeve)
Smar[Connect
TM
Refrigerator Tubing
Connection
[_TURN THE WATER ON AT THE
SHUTOFF VALVE
Tighten any connections that leak.
R{ attach the access cov( 1-.
[] PLUG IN THE REFRIGERATOR
Arrange the coil of tul)ing so thai it does not vii)rate
against Ill( ba(k of Ih_ retrigeralor or against Ill(
wall. Push the
l-el'l-igel-alOF
back 1o Ill{? wall.
[_START THE ICEMAKER
Set the icemakcr p(mcr switch to the I(on) position.
"['he i_cmakcr will not bugin to olmratu mltil it
rcaclu's its operating t(mpcrature of 15°F (-9(/)
or below. It will then begin oi)eration automatically
if' the icelnaker power switch is in the ! (on} positiofi.
NOTE: In lower water pressure conditions, tile
water valve may turn on up to 3 times to delixer
enough water 1o the icemaker.
13