Tabla de contenido
Publicidad
6.1. Drill chuck replacement.
Quick-release chuck is screwed onto spindle of the drill and additionally secured with a screw.
Set the direction selector switch (2) in middle position.
Open chuck jaws.
Unscrew the fixing screw with cross screwdriver by turning it clockwise (left-hand thread).
Install hex key in the chuck.
Gently tap the second end of the hex key.
Unscrew the chuck.
Installation of the chuck is similar to installation, only the sequence of actions is reversed.
6.2. The cordless drill is supplied with brushless electric motor.
6.3. All faults should be repaired by RAIDER service workshop.
6.4. The repair of your power is best carried out only by qualified specialists, which used only
original spare parts. This ensures their safety operation.
7. Environmental protection.
7.1. The machine, accessories and packaging should be sorted for environmental-friendly
recycling.
Do not dispose of power tools into household waste!
According the European Directive 2012/19/EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power tools that are no longer usable must be collected
separately and disposed of in an environmentally correct manner.
7.2. Battery packs/batteries:
Litium-Ion (Li-ion).
Warning! These battery packs contain cadmium, a highly toxic heavy metal.
Do not dispose of battery packs/batteries into household waste, fire or water. Battery packs/
batteries should be collected, recycled or disposed of in an environmental-friendly manner.
Defective or dead out battery packs/batteries must be recycled according the Directive 2006/66/EC
15
Publicidad
Tabla de contenido
