Installation Instructions; Cleaning And Care - HoMedics TOTALCOMFORT UHE-CMTF28 Manual De Instrucciones E Información De Garantía

If you live in an area with hard water or use a water softener, we recommend using distilled water for
best results. Never use water-softening additives in your humidifier.

INSTALLATION INSTRUCTIONS

1. Remove demineralization cartridge from packaging and soak
in water for 10 minutes.
2. Remove the tank cap.
3. Fill the tank with water as shown in the How to Fill section of
this instruction book.
4. Add the soaked demineralization cartridge to the tank.
5. Replace the tank cap on the humidifier.

CLEANING AND CARE

CAUTION: Before cleaning the unit, turn power off and unplug unit from the outlet.
CLEANING THE TRANSDUCER/ULTRASONIC MEMBRANE
The transducer/ultrasonic membrane must be cleaned to remove water mineral deposits when the red
LED is illuminated above the clean transducer/ultrasonic membrane button. Failure to do so may cause
reduced or no mist output.
12 8
1 2 3
1. Remove the tank cap,
tank cover, and tank
and set aside.
To purchase new Demineralization Cartridges, Model # UHE-HDC4, go to the retailer where you purchased your HoMedics TotalComfort
Ultrasonic Humidifier, or visit www.homedics.com (US), www.homedics.ca (CAN).
2. Remove the tank and pour out
any water remaining in the
tank.
10
Demineralization Cartridge
3. Pour out any remaining water
inside the water reservoir by
pouring in the direction of the
drain arrow.