Installing The Sauna Control Unit; Connecting Wires - Karibu 70444 Instrucciones De Montaje Y De Servicio

Instructions for installation and use

4.1. Installing the sauna control unit

Refer to Fig. 1 (page 10) and Fig. 2 (page 11).
1. Screw three Phillips-head screws (20 mm) into the wall of the sauna ac-
cording to Fig. 1 at a height of approx. 1.70 m and a distance of 7 mm
(see Detail of Fig. 2).
2. Using the attachment device, hang the sauna control unit on the upper
Phillips-head screw so that the control unit rests on the bottom two screws.
3. Ensure that the sauna control unit is fitted securely.

4.2. Connecting wires

Refer to Fig. 3 (page 11).
1. Insert the plug of the heater sensor wire 4 into the socket for the heater
sensor 1.
2. Insert the plug of the bench sensor wire 3 into the socket for the bench
sensor 2.
3. Insert the plug for the heater, power supply and light wire 5, 6, 7 into
the respective sockets 8, 9, a.
Fig. 1
WORLD OF WELLNESS
18,2 cm
p. 10/22