RISCO Group VUpoint RVCM52W Guia De Instalacion página 11

Indication
Red light normally on
Green light slow
flashing
Green light quick
flashing
Green light normally
on
Red and green lights
flash alternately
Red light slow flashing
Red light quick
flashing
Powering-up the IP Camera
1. Connect power to the Power port on the IP camera.
2. Connect power to an electrical outlet. When the IP camera boots up, the
GREEN power indicator light turns on.
Connecting the IP Camera to the Network
The IP camera supports several network connection options including LAN and
Wireless.
Connecting to a LAN Network
Connecting the IP camera to a network using the LAN (Local Area Network)
enables easy connection and setup with compatible APs (Access Points), e.g.
gateway or router.
Status
Booting
Booting completed, await WiFi config, enter smart config status;
WiFi smart config in progress, including WPS (WiFi Protected
Setup), management frame and etc.
Wifi connection succeeded, operate normally.
Device upgrade
Network connection failure or disconnection after network
connection success.
Device malfunction, fail to boot up; alarm or SD card
malfunction
9