RISCO Group VUpoint RVCM52W Guia De Instalacion página 15

7. Click Add.
If the "Connect to WiFi" message is displayed, go straight to step 8.
Figure 10 Connect to WiFi message
NOTE – This message is only relevant for IP cameras that are physically
connected to the LAN network via the router.
8. Select one of the following options:
Connect to Wi-Fi – to establish a wireless network connection (go to step 9 to
connect the IP camera to the wireless network).
Not Now – to establish a LAN network connection (skip the wireless network
connection steps 9, 10 and 11 and connect the IP camera to the LAN network).
9. If you selected the "Connect to Wi-Fi" option, a list of available wireless
networks is displayed.
Figure 11 List of available wireless networks
10. Select a wireless network from the available list and click Connect.
NOTE – If your network is password protected, a password must be entered into
the displayed password screen.
11. Click OK to establish the wireless connection (Refer to Connecting to a
Wireless Network using the RISCO Cloud).
IMPORTANT – Once a wireless connection has been established, don't forget to
disconnect the IP camera Ethernet cable from the router.
13