NIOSH RPB T-LINK Manual De Instrucciones página 16

SETUP AND USE
DONNING YOUR HELMET
Once you have completed the set up, you are ready to fit your RPB
check inside the hood to ensure that it is free of dust, dirt or contaminants.
FIGURE 7.1
Then open the bottom of the hood with the air
flowing from the air source, put the respirator
onto your head. Make sure the hood is
centered on your head.
Tuck the inner bib into the collar of your
shirt, overalls, or protective gear to prevent
contaminants from entering the hood. Pull the
outer bib down.
16
CONTINUED
FIGURE 7.3
T-LINK
®
Pull the hood down, tighten the head harness
ratchet to fit, and make sure the neck seal is
sealing around your neck, making sure the
elastic is tied securely.
FIGURE 7.4
Fasten the flow control device belt around
your waist over hip.
Respirator. First,
®
FIGURE 7.2