Texi Apollo 68 Manual De Usuario página 26

EN
SECURITY SYSTEM OF ELECTRICITY
If the iron is close for 15 seconds or open and out of use for some minutes,
electricity system will be stopped automatically. Heating system will restart working
by opening iron. By all means lock the appliance before moving. Keep iron closed
and press down 2 locking buttons. After you finish ironing wait for 30 minutes in
order for iron to be cool and then close it.
Note! Before carrying or putting iron in standing position, make water of tank
empty to prevent pouring.
ELECTRONIC MINERALS CONTROLLING SYSTEM-EMC
The iron is equipped with Electronic Minerals Controlling system (EMC) and
presented with an anti-sediment cartridge. EMC system controls the efficiency of
anti-sediment cartridge and ever tests the amount of minerals existing in filtered
water. It removes any single possibility of sediment therefore there is no need to rub
sediment off from your iron.
GUIDE-LIGHT FOR SWAPPING ANTI-SEDIMENT CARTRIDGE
The guide-light indicates that anti-sediment cartridge should be swapped. When
anti-sediment cartridge becomes worn out, EMC turns on the guide-light for
warning you to swap it. If you do not swap cartridge, EMC will stop producing steam
automatically. In this case the guide-light will be on continuously. To reproduce
steam, you should swap the anti-sediment cartridge or use distilled water. After
swapping, turn your iron on and off in order to make it return to the primary
conditions.
MAINTENANCE
Keep your iron clean by washing the outer parts of it with very little foam of soap
and then wiping off with a soft cloth.
Coating:
Make sure that coating is ever in pulled manner in order not to make wrinkle. Wash
in water at 40˚ centigrade. Never wash with white clothes. In case of being worn out,
swap it.
Heated Sheet:
The starch of cloth, the remains of washing materials and tiny fragments of thread
make some spots on the heated sheet in all irons gradually. Clean it while being a
26 Texi Apollo 68 / Texi Apollo 101