Installation Procedure - Rockwell Automation Allen-Bradley SLC 5/01 Instrucciones De Instalación

Installation Procedure

Install the Battery
Important: If your processor has a battery— the battery is an option for the SLC
5/01 (1747-L511) processor — make sure it is connected before
installing your processor into the chassis. This provides memory
backup for your processor should the controller power supply fail.
1. Open the door of the processor.
2. Remove the jumper from the battery connector socket. Store the jumper in
a safe place for possible future use without the battery.
3. Insert a new or replacement battery in the holder making sure it is held in by
the retainer clips.
4. Plug the battery connector into the socket. See the figure below.
White
Lead
Red
Lead
5. Close the processor door.
Important: See page 10 for information on proper battery handling, storage, and
transporting.
Battery
Connector
+
Retainer
Clips
7
Publication 1747-5.25