Apply Power To The Processor - Rockwell Automation Allen-Bradley SLC 5/01 Instrucciones De Instalación

8
Install the Processor
Make sure system power is off; then insert the processor into slot 0 of the 1746
chassis.
Important: The SLC 500t Modular Processors must be inserted into the left slot
(slot 0), as shown below. In addition, remove the protective wrap after
installing the processor.
Power
Supply
Protective Wrap

Apply Power to the Processor

1. Energize the chassis power supply.
2. Check the chassis power supply and processor LEDs. The power LED on the
power supply should be on and the fault LED on the processor should be
flashing.
POWER
Publication 1747-5.25
Card Guide
COMM
RUN
CPU FAULT
FORCED I/O
BATTERY LOW
The RUN LED on the SLC 5/01
processor is actully labeled "PC
RUN." Also, the SLC 5/01 processor
does not have a COMM LED.
Processor
Release
Indicates the LED is OFF.
Indicates the LED is ON.
Indicates the LED is
FLASHING.
Status of LED does not matter.