Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
D
1509)50-4
If you have a problem, read this
Your dishwasher may not work or not function properly. In many cases, these are problems which can be
solved without having to call for a technician. Before calling the service centre, always check the points
below.
The dishwasher won't
start
I Is the water supply tap turned
on?
I Is the water supply tap
connected to the hose properly?
I Has the water in your home
been cut off?
I Is the pressure of the water
supply sufficient?
I Is the hose bent?
I Is the filter on the water supply
hose blocked?
I Is the dishwasher door open?
The dishes are not
clean.
I Have you put the right amount
of detergent into the
dispenser?
I Is the wash cycle suitable for
the dishes you have placed
inside the appliance?
I Are the filter and microfilter
clean?
I Can the sprayer arms turn
freely?
Safety within your home
Your dishwasher was built in accordance with the strictest international safety regulations. They protect
you and your family. Read the instructions and information contained in this manual: they will provide
you with useful hints as to installation, use and maintenance safety. To avoid nasty surprises.
1. Dispose
of
packaging
material
carefully (follow the
instructions on how to
divide your rubbish up
provided by your local
Council)
2. After removing the
packaging, check to
make
sure
appliance is intact. If in
doubt,
contact
qualified professional.
3. Your dishwasher must
only be used by adults
and
for
washing
household
dishes,
according
to
instructions included in
this manual. Do not
touch the appliance
with wet hands or feet
or barefoot.
4. We discourage the use
of extension leads and
multiple plugs. If the
electricity supply wire is
not long enough, then
have it replaced with
one of the correct length
20 ARISTON DISHWASHER - Instructions for installation and use
Troubleshooting
The dishwasher won't
drain.
I Is the drain hose bent?
Limescale deposits or a
white film form on the
dishes.
I Is the lid on the salt container
closed properly?
I Is the rinse aid dosage correct?
Error messages
Your dishwasher is equipped with
a safety system which is able to
detect any operating anomalies.
These anomalies are reported by
one or two cycle indicator lights
"M" flashing rapidly. Take a note of
which lights are flashing, turn the
appliance off and call for technical
assistance.
Tap off alarm
If you have forgotten to turn the
water tap on, your appliance will
remind you of this by sounding a
few short beeps for a few minutes.
the
and remember that it
should be free of bends
or dangerous kinks.
5. If the appliance is not
operating properly or if
maintenance operations
are
necessary,
disconnect
dishwasher from the
your
mains power supply
(unplug it!).
a
6. Keep children away
from the dishwasher
when it is open and
keep detergents out of
their reach.
7. Your dishwasher is not
the
to be installed outdoors,
not even if the area is
covered by a roof: it is
extremely dangerous to
leave it exposed to rain
and thunderstorms.
8. Do
not
touch
heating element during
or straight after a wash
cycle.
9. Do not lean or sit on the
door when it is open, as
this could overturn the
Turn the tap on and your appliance
will start up again after a few min-
utes. Were you to be absent when
these beeps are sounded, the appli-
ance will be blocked automatically
and cycle 4 and 5 indicator lights
(rapid and soak cycle) will flash
rapidly. Turn the appliance off at
the ON-OFF button, turn on the
water tap and wait approximately
20 seconds before turning the ap-
pliance back on, the wash cycle
will start up again.
Clogged filter alarm
If the appliance is blocked and
wash cycle3 and 5 indicator lights
(auto eco and soak) flash rapidly,
this means the filter is clogged by
large particles of food residue. Turn
the appliance off, clean the filter
thoroughly and reposition it in its
seat as illustrated on page 21. Then
turn the appliance back on.
Re-select a wash cycle as indi-
cated in the "Selecting the wash
cycle" paragraph and the appliance
will start.
dishwasher.
10. If
the
appliance
malfunctions, turn off
the water inlet tap and
disconnect the plug
from the wall socket.
Then try consulting the
section entitled "I you
the
have a problem, read
this". If you cannot
resolve the problem,
then call the service
centre.
11. Once taken out of use,
appliances must be
made inoperable: cut
the power supply wire
and damage the door
lock.
12. The door should not be
left in the open position
since this could present
a tripping hazard.
13. Disposal of old electrical
the
appliances
The European Directive
2002/96/EC on Waste
Electrical
Electronic Equipment
(WEEE), requires that
Water load solenoid valve
malfunction alarm.
If indicator light 4 (Rapid) flashes
rapidly, TURN the dishwasher OFF
AND BACK ON AGAIN after one
minute. If the alarm persists, first
turn off the water tap to avoid any
flooding and then cut off the
electricity supply and call for
technical assistance.
You
have
checked
everything, but the
dishwasher still doesn't
work and the problem
persists?
Call an authorised service centre
near you and remember to
mention:
• the type of malfunction
• the model mark (Mod....) and
the serial number (S/N....)
indicated on the rating plate
located on the inner door, to one
side.
Never call upon the
services of
unauthorised
technicians and
always refuse spare
parts that are not
originals.
old household electrical
appliances must not be
disposed of in the
normal
municipal
stream. Old appliances
must
be
separately in order to
optimise the recovery
and recycling of the
materials they contain
and reduce the impact
on human health and
the environment. The
crossed out "wheeled
bin" symbol on the
product reminds you of
your obligation, that
when you dispose of the
appliance it must be
separately collected.
Consumers
contact
their
authority or retailer for
information concerning
the correct disposal of
their old appliance.
and
unsorted
waste
collected
should
local
Publicidad
Tabla de contenido
