Dimplex CONNEX CST-240 Manual De Instrucciones página 12

To sync a CONNEX™ wireless controller to your CST-240
thermostat instead of a CONNEX™ heater, place your
controller in sync mode and follow the below instructions
Press the synchronization button for 5 seconds to enter
the CST-240 into a pairing mode with a CONNEX™
wireless controller. While the unit is in sync mode, the
displays for 30 seconds and it will be able to receive an
RF message and update its sync information. If the unit
has not successfully synced in 30 seconds, the X symbol
displays.
+
Press the + (up) button to increase the temperature set
point by 0.5°C (1°F) up to a maximum of 30°C (86°F).
Press the − (down) button to decrease the temperature
−
set point by 0.5°C (1°F) up to a minimum of 5°C (41°F).
Press the + and − buttons at the same time to toggle the
display and set point information between °C and °F.
This function disables all buttons until the child
lock is disabled
Press a sequence of +, −, +. −, +, − to enable the
child lock and disable all button functions. The
CST-240 will still respond to wireless controller
commands.
Press a sequence of −, +. −, +, −, + to disable the
child lock.
CST-240 12 www.dimplex.com