Parts and Functions
Remote controller
1
2
3
4
5
HEALTH
ON/OFF
12
13
FAN
MODE
14
SWING
15
TIMER
16
CLOCK
SET
SLEEP
17
LOCK
RESET
18
1. Operation mode display
Operation mode
AUTO
COOL
Remote controller
Display board
2. SWING display
3. FAN SPEED display
AUTO
4. HEA LTH display
5. SLEEP display
6. LOCK display
Clock set
When unit is started for the first time and after replacing batteries in remote controller ,
clock should be adjusted as follows:
Press CLOCK button, "AM" or "PM" flashes.
Press
or
to set correct time. Each press will increase or decrease 1min. If the
button is kept depressed, time will change quickly.
After time setting is confirmed, press SET, "AM "and "PM" stop flashing, while clock
starts working.
NOTE: Cooling only unit do not have displays and functions related with heating
Hints
After replacing with new batteries, remote controller will conduct self-check, displaying
all information on LCD. Then, it will become normal.
6
7
8
9
10
25
11
7. SIGNAL SENDING display
19
8. TIMER OFF display
20
9. TIMER ON display
10. CLOCK display
11. TEMP display
21
12. HEALTH
13. FAN
22
14. SWING
23
15. TIMER
16. CLOCK
24
17. SET
18. LOCK
19. POWER ON/OFF
20. TEMP.
21. MODE
FAN
DRY
HEAT
22. HOUR
23. SLEEP
24. RESET
LO
MED
HI
25. Singal receiver hole
26. Ambient temp.display
6
Display board
4
1
26
1
Used to operate the healthy function
Used to select fan speed LO, MED, HI, AUTO
Used to set auto fan direction.
Used to select TIMER ON, TIMER OFF,
TIMER ON OFF
Used to set correct time
Used to confirm timer and clock settings.
Used to lock buttons and LCD display.
Used for unit start and stop.
Used to select your desired temp.
Used to select AUTO run, COOL, DRY and FAN operation
Used to set clock and timer setting.
Used to select sleep mode.
Used to reset the controller back to
normal condition.
When receiving the remote control signal, display the set
temperature and in the rest time the room temperature is
displayed and this room temperature is only for reference.
1
8 9
5