D-Link DAP-1650 Guía De Instalación Rápida página 6

TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1. HOW DO I CONFIGURE MY DAP-1650 AP WITHOUT THE CD, OR CHECK MY WIRELESS
NETWORK NAME (SSID) AND WIRELESS ENCRYPTION KEY?
- Connect your PC to the range extender using an Ethernet cable.
- Open a web browser and enter the address http://dlinkap.local or http://192.168.0.50
- The default username is 'Admin'. The default password is blank (leave the field blank).
- If you have changed the password and can not remember it, you will need to reset the AP to
revert the password back to blank (leave the field blank).
2. HOW DO I RESET MY DAP-1650 AP TO FACTORY DEFAULT SETTINGS?
- Ensure the range extender is powered on.
- Press and hold the reset button on the bottom of the device for 5 seconds.
Note: Resetting the range extender to factory default will erase the current configuration
settings. To re-configure your settings, log into the range extender as outlined in question 1, then
run the Setup Wizard.
3. HOW DO I ADD A NEW WIRELESS CLIENT OR PC IF I HAVE FORGOTTEN MY
WIRELESS NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
- For every PC that needs to connect to the range extender wirelessly, you will need to ensure
you use the correct Wireless Network Name (SSID) and encryption key.
- Use the web based user interface (as described in question 1 above) to check or choose your
wireless settings.
- Make sure you write down these settings so that you can enter them into each wirelessly
connected client. You will find a dedicated area on the back of this document, this important
information for future use.
6
DAP-1650