Hoover IronSpeed Smart Manual Del Usuario página 8

6 - GB
Chapter 2.3 - Switching on the Appliance
Connect the appliance with the mains cord to an earthed socket and switch on the
power. Press the on/off switch. The light (1a) will illuminate, this tells you that the
appliance is working and that the boiler is heating up.
After approximately 2 minutes, the "steam ready" led will light off and you can now
start to use the steam feature.
N.B.
The first time the appliance is used, you may find some fumes, dust and a smell
should appear.
It's quite normal and will quickly disappear.
This is due to a treatment applied to the soleplate that improves the steam performance.
Before use, please use the iron as described in Chapter 3.4 Vertical Steam Ironing.
Chapter 3: Using Your Steam Generator
Chapter 3.1: Regulating the Soleplate Temperature
Select the temperature of the soleplate by turning the dial (6) on the iron to the desired position.
Wait a few moments until the temperature indicator (8) is off.
It will indicate to you that the soleplate has reached the requested temperature.
While ironing, the temperature dial indicator may turn on and off, the temperature
adjusts without interrupting your ironing.
Help
To know the best suitable temperature for each textile, check the laundry care label
of the article to be ironed. Please note that during use, the temperature light goes on
from time to time. It signifies that the iron is heating up to the set temperature.
If a fabric is made with various kinds of fibres always select the soleplate temperature
in adequacy with the most delicate one.
If you select a lower temperature while ironing, wait until the iron has cooled down to
the set temperature before you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate.
Please raise up the temperature above the 2 dots (••) to avoid this issue.
Chapter 3.2 - Ironing
Dry Ironing
Select the temperature of the soleplate following the indications of chapter 3.1. Start
your ironing without pressing the steam trigger (7), when the soleplate reaches the
appropriate temperature.
Steam Ironing
Select the temperature of the soleplate following the indications of chapter 3.1. The
steam will be ready to be used after 8 minutes and the dedicated lamp (1C) will turn
off. Starting from that time you can begin your ironing and press the steam trigger (7)
for having steam. The steam flow stops when you release the trigger.
N.B.
During use, you may hear noise coming from your steam generator. This is normal. It
signifies that a pump is injecting water into the boiler. Ideally, avoid using the steam
trigger at this precise moment to avoid a fall in pressure.