Lp Conversion; Gas Cooktop - GE PGP990 Manual Del Propietario E Instrucciones De Instalación

LP Conversion

Instructions
Questions? Call 800.GE.CARES (800.432.2737)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
FOR YOUR SAFETY:
WARNING –
If you are using LP (bottled) gas,
all adjustments described in the following steps must be
made before attempting burner adjustments or use of
the cooktop.
WARNING –
This conversion kit shall be
installed by a qualified service agency in accordance
with the manufacturer's instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instructions
is not followed exactly, a fire, explosion or production
of carbon monoxide may result, causing property
damage, personal injury or loss of life. The qualified
service agency is responsible for the proper installation
of this kit. The installation is not proper and complete
until the operation of the converted appliance is checked
as specified in the manufacturer's instructions supplied
with the kit.
Save these
Observe all
Be sure to leave these
Keep these

Gas Cooktop

or
Visit our Website at:
• This cooktop is factory set for natural gas operation.
Conversion to LP operation should be performed
by a qualified technician or installer. Keep these
instructions for future reference. When converting
to LP, save the original parts for possible future use.
• Product failure due to improper installation is not
covered under the GE Appliance Warranty.
TOOLS YOU WILL NEED
Small, thin-blade flat screwdriver with approximately 1/8"
blade width is needed to access the calibration screw.
PARTS INCLUDED
PART
Brass orifices
Stick-on conversion label
30
ge.com
Adjustable wrench
QUANTITY
4
1