Install The Cooktop - GE PGP990 Manual Del Propietario E Instrucciones De Instalación

10 PREPARE THE COOKTOP
Remove the vent grille, vent filter, sealed burner
module and the tape from the burner caps.
Turn the cooktop over (upside down) and gently
place it on the styrofoam packing.
Unscrew (loosen) the side hold-down screws.
Use styrofoam
to protect cooktop
Install the plenum to the cooktop using 4 screws.
The motor opening on the box goes toward the left
side of the unit (the side with the grease jar lid).
Installation Instructions

INSTALL THE COOKTOP

Loosen side
hold-down screws
26
10 PREPARE THE COOKTOP
Rotate the cooktop and plenum forward and
carefully set it on its back edge on the styrofoam
packing.
Install the blower assembly onto the plenum so
that the blower exhaust is pointing down or back
as needed. Push the bolts through the bolt holes
in the plenum.
From the vent opening in the top of the cooktop,
install the vent guard over the bolts. Use the 4 nuts
to secure the blower assembly and vent guard to
the inside of the plenum.
4 Nuts
(3/8" socket
required)
(cont.)
For back exhaust,
position blower outlet
in direction of this
arrow
For down
exhaust, position
blower outlet in
direction of this
arrow
Vent guard