Info; Light; Reset; Transmitter Status Indications - AKG SR 4500 Modo De Empleo

The ">INFO<" submenu lets you call up information about your receiver.
1. Select "X-TRA / EXTRA" -> ">INFO<".
2. Press and turn SETUP to call up the following screens:
- Software version
- Frequency band
- Preset version
- "EXIT": To leave the ">INFO<" submenu, press the SETUP control briefly. The display will revert to the
"X-TRA / EXTRA" menu.
The ">LIGHT<" submenu allows you to adjust the brightness of the display backlighting in 10 increments from dark
to bright. The selected setting is only active in LOCK mode. In ACTIVE mode, the display brightness is always at maxi-
mum.
1. Select "X-TRA / EXTRA" -> ">INFO<".
2. Press and turn SETUP to set the desired display brightness.
3. Press the SETUP control briefly. The selected setting will be saved and the display will revert to the "X-TRA / EXTRA"
menu.
The ">RESET<" submenu allows you to reset all parameters to their default values.
1. Select "X-TRA / EXTRA" -> ">RESET<".
2. Press and turn SETUP to leave your personal settings untouched ("NO") or to restore all receiver parameters to their
default values ("YES").
3. Press the SETUP control briefly to confirm your selection. The display will revert to the "X-TRA / EXTRA" menu.
1. ">TXMUTE<": When you mute the transmitter, the display starts flashing ">TXMUTE<" alternately with the cur-
rent receiver status indication. As soon as you reactivate the transmitter, the display will revert to the previous screen.
2. ">TX OFF<": When you switch power to the transmitter off, the display starts flashing ">TX OFF<" alterna-
tely with the current receiver status indication. The LED ring (Fig. 1, no. 5) will change to red for about five seconds.
As soon as you switch power the transmitter b ack on, the display will revert to the previous screen.
• These display functions are permanently active in all both LOCK and ACTIVE modes.
• Use a soft cloth moistened with water to clean the surfaces of the equipment.
SR 4500
4 Extra Functions

5 Cleaning

4.5 INFO

4.6 LIGHT

4.7 RESET

4.8 Transmitter Status Indications

27