Preparation For Operation; Floor Mounting - Chauvet Professional Cloud 9 Guía De Referencia Rápida

Preparation for Operation

To prepare the Cloud 9 for operation:
1. Open the flight case.
2. Pull out the fluid tank and remove the cap.
3. Verify that the two plastic hoses attached to the inside of the cap are in place and in good condition.
4. Pour Chauvet fog fluid inside the tank, and re-cap.
5. Reinsert the tank.
6. Make sure that the plastic hose that goes from the cap to the fogger is not bent.
7. Plug in power and wait approximately 4 minutes for warm-up to complete.
When storing the product, ALWAYS be sure to store the fluid tank with the cap up (see

Floor Mounting

cause leakage.
Only use Chauvet-approved fog fluid. Otherwise, you might not have satisfactory results.
In addition, unapproved fluid can damage the Cloud 9 or cause harm to humans or
animals.
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your Cloud 9.
Make sure you use FCQ regularly, no longer than 90 days between cleanings, to increase
the life of your product.
Operation
1. Place the machine on a level surface. Plug the power cord into the wall.
2. Remove the top lid.
3. Fill the water tank with distilled water to the maximum fill line located on the inside of the tank. The container can
hold up to 5.3 gal or (20 l).
4. Fill the fluid tank with CHAUVET haze or fog fluid to the maximum fill line located on the outside of the tank. The
container can hold up to 1 gal (3.5 l). Haze or fog fluid options for the Cloud 9:
• High-Density Fog Fluid (HDF) - Best overall performance for a medium to large coverage area. Fog
dissipates after lifting into the air.
• Premium Haze Fluid (PHF) - Creates a dual purpose effect. Good coverage area; fog lifts into the air to
become haze.
5. Turn the product on using the power switch on the back panel. Make sure the fans are operating properly.
6. Using the control panel, set the product to the desired operating mode.
• Filling the distilled water tank above the maximum fill line will reduce the
performance of the product. To ensure optimal performance, drain any excess
water via the overfill drain prior to use.
• Due to water evaporation, you may need to refill the Cloud 9 with water to continue
triggering the machine.
• The Cloud 9 is fitted with a safety shutoff feature, which prevents the unit's heaters
from turning on when the water level is too low. If this safety shutoff feature has
been engaged, simply add more water to continue using the Cloud 9.
• The Cloud 9 can operate with the top lid on or off.
• HDF will provide the best overall performance for a medium to large coverage area.
Fog dissipates after lifting into the air.
• PHF creates a dual purpose effect. Good coverage area; fog lifts into the air to
become haze.
Programming
Refer to the Menu Map to understand the menu options. The menu map shows the main level and a variable number of
programming levels for each option.
• To go to the desired main level, press <FUNCTION> repeatedly until the option shows on the display. This will take
you to the first programming level for that option.
• To select an option or value within the current programming level, press <UP> or <DOWN> until the option shows
on the display. If there is another programming level, you will see that first option, or you will see the selected value.
• Press <FUNCTION> repeatedly to exit to the previous main level.
Cloud 9 QRG Rev. 8
QUICK REFERENCE GUIDE
Diagram) before installing the front cover to avoid tube damage that may
EN
4