Rp 210 Diagnostic Codes - Emerson RIDGID RP 210 Manual Del Usuario

RP 210 Press Tool
Troubleshooting (Continued)
SYMPTOM
Yellow LED glows con-
tinuously and tool will
not begin press cycle
when trigger switch is
depressed.
Red LED blinks repeated-
ly and tool will not begin
press cycle when trigger
switch is depressed.
Yellow LED glows when
tool is turned ON.
Jaws are locked onto
fitting.
The pressed connections
produced are not com-
plete.

RP 210 Diagnostic Codes

LED Status
Green
Glows
Blinks
Blinks
Red
Glows
Blinks
Yellow
Glows
Figure 12 – LED Diagnostic Codes
12
POSSIBLE REASONS
Scheduled maintenance/recalibration is manda-
tory after 32,000 presses. Tool is "locked" and
will not function until tool is serviced.
Attachment mounting pin not fully closed.
Tool malfunction detected.
Press was not successfully completed.
Used wrong jaws for the tube size or material.
The tool was not square to the tube.
Jaw contour was not aligned with the fitting contour.
Tool is in need of repair.
Description
Tool ON.
Out of acceptable voltage range.
— Replace battery with a fully charged battery.
Attachment mounting pin not fully engaged. Insert pin.
If only red light is ON, Out of temperature range 15°F (-10°C) to 140°F (60°C).
Service indicator after 30,000 cycles. NOTE: Tool will lock after 32,000 cycles.
Machine is locked – Service after 32,000 cycles or after a malfunction.
SOLUTION
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Service
outlet.
Insert attachment mounting pin to the fully closed
position.
Remove and reinsert fully charged battery. Be sure
to repress fitting. If LED's continue to glow, contact
RIDGID Technical Service Depart ment at (800)
519-3456 for nearest Author ized Service outlet.
Push pressure release valve to remove jaws from fit-
ting. Inspect and repress fitting.
Install the correct jaws.
Redo the joint with new fitting and new tube.
Make sure that the tool is square to the tube.
Redo the joint with new tube and new fitting.
Make sure the jaw contour is aligned with the
fitting contour.
Contact RIDGID Technical Service De partment at
(800) 519-3456 for nearest Author ized Service out-
let.
Icon