Determine The Header Bracket Location; Sectional Door And One-Piece Door With Track - Craftsman 139.53927 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
STEP
1
Determine
the Header
Bracket
Location
To prevent possible SERIOUSINJURY or DEATH:
• Headerbracket MUST be RIGIDLYfastened to
structural support on header wall or ceiling, otherwise
garage door might not reverse when required. DONOT
install header bracket over drywall.
• Concrete anchors MUST be used if mounting header
bracket or 2x4 into masonry.
• NEVERtry to loosen, move or adjust garage door,
springs, cables, pulleys, brackets, or their hardware, all
of which are under EXTREME tension.
• ALWAYScall a trained door systems technician if
garage door binds, sticks, or is out of balance.An
unbalancedgarage door might not reverse when
required.
Header Wall
Unflnishe@
OPTIONAL
Ceiling
CEILING
MOUNT
FOR
HEADER
BRACKET
Vertical Centerline
of Garage Door
2x4
Structural
J
Supports
installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.
SECTIONAL DOOR
AND ONE-PIECE DOOR WITH TRACK
1. Close the door and mark the inside vertical
centerline of the garage door.
2. Extend the line onto the header wall above the
door.
You can fasten the header bracket within 4 feet
(1.20 m) of the left or right of the door center
only if a torsion spring or center bearing plate
is in the way; or you can attach it to the ceiling
(see page 14) when clearance is minimal. (It
may be mounted on the wall upside down if
necessary, to gain approximately
(1 cm) 1/2".)
If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13.
3. Open your door to the highest point of travel as
shown. Draw an intersecting horizontal line on the
header walt 3" (7.5 cm) above the high point. This
height will provide travel clearance for the top edge
of the door.
NOTE: Door clearance brackets are available for
sectional doors when headroom clearance is less
than 2" (5 cm). See accessory page 39.
Proceed to Step 2, page 14.
12
Ceiling
Header Wall
:
3" (7.5 cm) Track
Highest Point
of Travel
Door
Sectional door
with curved
track
One-piece
door with
horizontal
track
Header Wall
Track
Highest
Point
!

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido