Installation Instructions; Unpack Refrigerator - KitchenAid KSSC48QKS00 Instrucciones De Instalación

Flush Side Panel
1. Measure the distance from point A (as shown) to back wall.
2. Attach support board with screw or adhesive that is
compatible with aluminum and wood.
A
1 2
1. Support board
2. Attachment locations
3. Door
Recessed Inset Side Panel
1. Measure the distance from point A (as shown) to back wall.
2. Rout front edge of support board or attach ¹⁄₄ in. (6 mm)
board for retention in cabinet side trim.
A
1. Support board
2. Door
12
3
1
2
INSTALLATION
INSTRUCTIONS

Unpack Refrigerator

WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when
not completely installed.
Keep doors taped closed until refrigerator is
completely installed.
Use two or more people to move and install
refrigerator.
Failure do so can result in death or
serious injury.
IMPORTANT:
Do not lower the refrigerator against the shipping base when
removing the shipping base.
Do not remove protective film until refrigerator is in operating
position.
All four leveling legs must contact the floor to support and
stabilize the full weight of the refrigerator.
Keep cardboard shipping piece or plywood under refrigerator
until it is installed in the operating position.
1. Remove and save literature package and parts bag taped to
refrigerator door. Remove four brackets (two on each side)
attaching shipping base to refrigerator bottom.
NOTE: Do not remove tape and door bracing until refrigerator
is in final position.