Metra 99-5807 Instrucciones De Instalación página 8

ISO DDIN radio provision
1. Using a utility knife, carefully cut out the
center divider from radio housing (a).
2. Slide the ISO double DIN brackets over the
mounting legs of radio housing (a), aligning
the holes together. (Figure B)
3. From the back, slide the radio between the
completed assembly, and then secure the radio
using the screws supplied with the radio. (Figure C)
Note: The notch in the housing
should be on top.
(Figure A)
METRA. The World's best kits.
Installation instructions for part 99-5807
Kit Assembly
(Figure B)
(Figure C)
™
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER