Bebecar minibob LA3 Manual Del Usuario página 11

GB
IMPORTANT - READ THE INSTRUCTIONS
CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE
REMEMBER YOUR CHILD'S SAFETY IS YOUR RESPONSIBILITY
WARNING: This carrycot has been designed to be operated as shown in the
instructions supplied.
Not to do so may cause damage and render your guarantee void.
A - Remove the apron and mattress from the carrycot and pivot the metal formers
towards the upright position.
B - Fit the mattress and liner as shown.
NB: The mattress liner makes part of the carrycot, so never use the carrycot
without it.
C - The carrycot backrest can be raised or lowered by adjusting the metal support
behind it.
D - To fit the hood, insert bayonet fitting into slots of the carrycot.
E - To remove the hood, press on the outside edge of the carrycot at the position of
the bayonet.
F - Integrated and adjustable air ventilation base system providing the baby with a
natural well-being when reposing in the carrycot.
G - To fully open the hood, press down on levers in side pocket of hood.
H - To fully close the hood: Firstly press down on tab on the inside of each side
pocket of hood to unlock handle, then lower hood slightly.
Finally lift up levers inside each pocket of hood to lower hood completely
I - To lift or carry the carrycot, use handle integrated in hood.
Warning: First ensure that the hood is secured correctly into the carrycot.
Then make sure that the hood is locked upright by pulling it forward until it
«clicks» into locking position.
J - To stabilize the carrycot base pull out the four plastic feet located in the corners of
the carrycot base.
To enable the rocking feature push the four feet into the carrycot base.
K - TO FIT CARRYCOT: Place carrycot base on chassis attachment device
"easylock". Lock will automatically engage.
Warning: Check that the pram body attachment devices are correctly engaged
before use.
L - TO REMOVE CARRYCOT: Push in button on base of the carrycot and
simultaneously lift carrycot away from chassis frame.