Samson RESOUND VX8.1 Manual Del Usuario página 14

Using Two Resound VX8.1 Systems
Daisy-chaining two Resound VX8.1 systems
This method is convenient when you don't have a mixer or have minimal input sources.
1. Connect the all of the input sources to the main Resound VX8.1 system.
2. Set the MIX / INPUT 1 switch to the down MIX position.
3.
Connect an XLR cable from the THRU output on the main Resound VX8.1 to the INPUT
1 of the second Resound VX8.1 system.
4. On the second Resound VX8.1, set the INPUT 1 MIC / LINE switch to the LINE
position.
5.
Set the level of the audio of the main Resound VX8.1 system.
6. Raise the INPUT 1 Volume control of the second Resound VX8.1 until the desired
output level is reached.
NOTE: When connecting another powered speaker system to the THRU Output of the
Resound VX8.1, it is important to power on the main Resound VX8.1 system first, then
power on the linked speaker. When powering down the system, it is recommended to
turn off all linked speakers, then power off the main Resound VX8.1 system.
14