Installing The Light Kit - HAMPTON BAY Windward II Manual Del Propietário

BLADE BALANCING
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level
by selecting a point on the ceiling above
the tip of one of the blades. Measure from
a point on the center of each blade to the
point on the ceiling. Measure this distance
as shown in Figure 15. Rotate the fan until
the next blade is positioned for measure-
ment. Repeat for each blade. Measurement
deviations should within 1/8". Run the fan
for 10 minutes.
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
10.
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADE HOLDERS WHILE
INSTALLING, BALANCING THE BLADES, OR
CLEANING THE FAN. DO NOT INSERT FOREIGN
OBJECTS BETWEEN ROTATING BLADES.

Installing the Light Kit

CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
1. Loosen 2 opposite mounting screws on the
black bracket below the motor and remove
the other two screws.
2. Connect the blue wire exiting the bottom of
the fan motor assembly with the black wire
from the top of the light kit fitter assembly.
Connect the white wire exiting the bottom
of the fan motor assembly with the white
wire from the top of the light kit fitter as-
sembly (see page 8 for diagram).
3. Attach the light kit assembly to the fan motor
assembly by securing with the two screws
loosened in step 1. Push light kit assembly
up to engage screw heads in slots and turn to
secure. Tighten each screw firmly.
4. With the power off, install the circline lamp
(MAX. 30W) provided into the light kit
assembly.
Figure 15
5. Attach the glass shade to the light kit assem-
bly by aligning slots in top of glass shade
with ridges in light kit assembly. Push glass
shade up and twist to secure (Figure 16).
DO NOT OVERTIGHTEN WHEN INSTALLING THE
GLASS SHADE INTO THE LIGHT KIT ASSEMBLY.
ALLOW THE GLASS SHADE TO COOL COM-
PLETELY BEFORE REMOVING.
Black
Bracket
Figure 16