Installing The Light Kit - HAMPTON BAY Clarkston El Manual Del Propietario

8.Installing the Light Kit

NOTE
BEFORE STARTING INSTALLATION, DISCONNECT
THE POWER BY TURNING OFF THE CIRCUIT
BREAKER OR REMOVING THE FUSE AT FUSE BOX.
Step 1. D isassemble the switch house cover by removing
3 screws on switch house. (Figure 12)
Step 2. Remove 3 screws in the light kit. While holding the
light kit assembly under your fan, snap together the wire
connection plugs. (Figure 13)
Step 3. Carefully push all wires back into the switch
housing, then install the light kit assembly onto the switch
house with the 3 screws removed. Be sure to tighten all
screws. (Figure 13)
Step 4. To install light kit glass shade, loosen the light kit
screws and install the glass shade to the light kit. Secure
by tightening the 3 screws previously loosened. (Figure 14 )
Step 5. Install 3×60W candelabra bulbs (included).
Restore power and your light kit is ready for operations.
NOTE
MAKE SURE TO LEAVE ENOUGH SPACE BETWEEN
THE FAN PULL CHAIN AND THE BULBS TO THE
CHAIN DOESN T ' RUB AGAINST ANY OF THE BULBS.
LIGHT BULBS HAVE NO WARRANTY, CAN BE
PURCHASED AT LOCAL HOME IMPROVEMENT
STORE OR FROM OUR SERVICE CENTER.
7
Housing
Screws
Switch House
Cover
Figure 12
Housing
Light Kit
Figure 14
Housing
Switch House
Connection
Plug
Screw
Light Kit
Figure 13
Glass shade
assembly
Bulb
Switch House
Connection
Plug
Screw
Light kit
screw
Light kit
screw