Ordering Replacement Parts; Disposal And Recycling - EINHELL GC-SR 12 Manual De Instrucciones Original

sure that you do not leave out any patches.
•
Afterwards, treat (e.g. water) the area to
which the spreading material has been
applied in accordance with the instructions on
the fertilizer/seed packaging.
7. Cleaning and ordering spare
parts
7.1 Cleaning
•
Tip all remaining spreader material
which is left over in the spreader material
compartment after use back into the spreader
material packaging.
•
Move the adjustment lever to position "8" and
thoroughly clean the spreading holes and the
cover rail with a brush.
•
Wipe the equipment with a clean cloth or
blow it with compressed air at low pressure.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment.

7.2 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
GB
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
The reprinting or reproduction by any other
means, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes
- 12 -