Connecting The Pdu; Networking The Pdu - Tripp-Lite PDUMVR20NET Manual Del Propietário

Installation

Connecting the PDU

2-1
Connect the input plug to your facility's
compatible AC power source.
2-2
All models contain 2 banks of output
receptacles.
• PDUMVR20NET and PDUMVR30NET
contain 2 banks of 12 5-15/20R
receptacles (24 total).
• PDUMVR30HVNET contains 2 banks
of 10 C13 and 2 C19 receptacles
(24 total).
Connect your equipment's input plugs
to the appropriate outlets on the PDU.
On the Switched models, the LED near
each outlet illuminates when the outlet
is ready to distribute live AC power.
Note: It is recommended that you do not
connect a live load to the PDU. If the load
you intend to connect has an ON/OFF
switch, please turn the switch to OFF prior to
connection.
2-3
(Optional) If you attached the cord
retention bracket(s), tie each equipment
power cord to the retention bracket.
Attach each cord to the retention shelf
by looping the cord and securing it with
one of the included cable ties
sure each cord can be unplugged from
the PDU without removing the cable tie.

Networking the PDU

Note: The MAC address of the PDU (a 12-digit string in this format: 00 06 67 XX XX XX) is printed on a label
attached to the PDU enclosure.
If your network's DHCP server will assign a dynamic IP address to the PDU automatically, go
to Step . If you will assign a static IP address to the PDU manually, go to Step
3-1
are uncertain which method to use, contact your network administrator for assistance before
continuing the installation process.
16-10-211-933668.indb 4
Plug type may vary by model.
PDUMVR30HVNET Shown
. Make
A
PDUMVR30HVNET Shown
4
A
. If you
4-1
12/22/2016 11:36:15 AM