Start-Up; Use; Care And Storage; In The Event Of Problems - Beurer FM39 Instrucciones Para El Uso

8. Start-up

• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.

9. Use

When seated comfortably place your feet on the two platforms.
prevent it from sliding.
Switch on the massager with the ( ) button. Press the ( ) button again to activate the heat function. Press the
( ) button repeatedly to switch the device off.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the contact
pressure if you find it is painful or unpleasant.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer can
over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.

10. Care and storage

Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device
or accessories.
• Clean the device with a slightly damp cloth. If it is very dirty, you can also moisten the cloth with a
mild soapy solution.
• Small marks can be removed using a cloth or damp sponge, and some liquid delicate laundry detergent
where necessary. Do not use any solvent-based cleaning products.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry place
without weighting it down.

11. In the event of problems

Problem Cause
Massage heads The load on the massage
rotating at heads is too great.
reduced speed.
Massage heads Appliance not connected to
not moving. the power supply.
Overheating protection
tripped.

12. Technical specifications

Disposal 220-240 V~, 50/60 Hz, 25 W
The rubber feet on the base of the unit
Remedy
Release the massage heads.
Connect the plug to the mains supply and switch on
the appliance.
Disconnect the device from the power supply, wait at
least 15 minutes, then plug in again and switch on.
13