Start-Up; Operation; Care And Storage - Beurer CM 50 Instrucciones Para El Uso

6. Start-up

• Remove the packaging
• Check the device, power supply and cables for damage.
• Connect the power supply plug to the massage device.
• Route the cable safely so that there is no risk of anyone tripping over it.

7. Operation

Press the massager carefully against the part of the body that you wish to massage.
Stop the massage or change your position or the contact pressure if you find it is painful or unpleasant.
Do not trap or force any part of your body, in particular your fingers, between the rotating massage rollers.
Switch on the massager using the sliding switch. The massage rollers start to rotate. You can choose between
high and low speed. To switch off the device, push the sliding switch into the 0 position.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.

8. Care and storage

CLEANING
WARNING
• Before cleaning disconnect the power supply unit from the mains socket and disconnect it from the
device.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device
or accessories.
• The massage rollers can be removed by pulling firmly. The roller attachment can be cleaned under
running water with a soft brush and a little washing-up liquid.
The device can be cleaned with a soft, slightly damp cloth.
• Do not use the device again until it is completely dry.
Storage
If you do not use the device for longer periods, we recommend storing it in the original packaging in a dry
place without weighting it down.
12