STEAMONE M1300 Guía De Utilización página 18

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
USING THE STEAM MOP
IMPORTANT: Always insure that the unit is "UNPLUGGED" from the wall
receptacle prior to filling and before attaching the micro-fiber towel to the
bottom of the mop head. Never use the steam mop without the micro-fiber
towel attached to the mop head. Never use the steam mop without the micro-
fiber Towel attached to the mop head or without water in the water tank.
Please note that when using for the first time, the appliance may take longer
than the normal 35 seconds startup time to steam. You may need to wait a few
second before the steam is released. This is due to the water making its way
from the water tank through the pump and into the heater. This will only occur
during the first useWhen using your new steam mop for the first time you may
notice water residue inside of the unit. Water drops can also be found in the
packaging. This is normal and you should not be alarmed. Each steam mop is
100% tested in the factory to ensure product performance and safety.
Sometimes water is left in the unit from these test procedures
1. Sweep or vacuum floors before using the steam mop.
2. Twist the quick release cord holder to unwrap the power cord completely.
3. Plug into a 220-240volt electrical outlet.
4. Press the Power switch, the power "On" light will turn blue.
5. It takes approximately 35 seconds for the unit to heat up and the steam to
be ready.
6. The water pump is control by electrical inductor, when you have pull the
steam mop backward, if the angle more than 20 degrees, the water pump
will star by itself and then release powerful steam.(Fig.4)
7. When you have pull the steam mop frontward, if the steam mop stand-
alone verticality. The pump will stop delivering water to the boiler and the
steam will reduce to a stop when the boiler becomes empty.
12
8. When the water tank is empty, the steam mop will stop emitting steam.
Unplug the power cord from the electrical outlet and refill the water tank
following the instructions above.
9. When you have finished using the steam mop, unplug the unit from the
electrical outlet and carefully remove the micro-fiber cleaning pad from the
mop head. Please note that the micro-fiber cleaning pad gets very hot with
the steam. Always use caution when removing.
HELPUL HINTS
1. Always vacuum or sweep before using the steam mop.
2. The easiest way to use the steam mop is to tilt the ergonomic handle to a
45°angle and clean slowly.
3. A good amount of steam passes through the micro-fiber towel. We
recommend that the towel be changed when it gets too wet. These need to
be replaced as necessary.
4. To remove stubborn stains from vinyl or linoleum floors, pre-treat with a
mild detergent and some water before using the steam mop.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido