Care & Maintenance - BLUEFIN Fitness KICK 2.5 Manual De Instrucciones

CARE & MAINTENANCE
WARNING
TO PREVENT ELECTRICAL SHOCK, PLEASE TURN OFF AND UNPLUG THE TREADMILL
BEFORE CLEANING OR PERFORMING ROUTINE MAINTENANCE.
ALWAYS CHECK THE WEAR AND TEAR COMPONENTS LIKE FOOT LOCK LATCH TUBE
AND RUNNING BELT TO PREVENT INJURY.
Cleaning:
After each exercise, ensure that the unit is wiped down and any sweat is removed
from the unit.
The treadmill can be cleaned with a soft cloth and mild detergent. Do not use abrasives
or solvents. Be careful not to get excessive moisture on the display panel as this might
damage the unit and create an electrical hazard.
Please keep the treadmill, especially the computer console, out of direct sunlight to
prevent damage to the screen.
Storage:
Store the treadmill in a clean and dry indoor environment. Never leave or use the unit
outdoors. Ensure the master power switch is off and the power cord is un-plugged
from wall outlet.
TROUBLESHOOTING
PROBLEM POTENTIAL CAUSES
Treadmill will not Treadmill not plugged in.
start.
Safety Tether Key is not correctly
installed.
Circuit breaker (home) has been
tripped.
Treadmill circuit breaker has been
tripped.
Belt slips. Belt not tight enough.
Belt hesitates Not enough lubrication applied onto
when stepped on. the running belt.
Belt is too tight.
Belt is not Running belt tension not even
centered. across the rear roller.
CORRECTIONS
Plug the power cord into
a wall outlet.
Reinstall the Safety
Tether Key.
Reset the circuit breaker,
or call an electrician
to replace the circuit
breaker.
Wait 5 minutes and
then try to restart the
treadmill.
Adjust belt tension.
Apply lubricant.
Adjust belt tension.
Centre the belt.