Brinkmann 810-5530-S Manual Del Propietário página 7

C C Y Y L L I I N N D D E E R R S S P P E E C C I I F F I I C C A A T T I I O O N N S S : :
Any fuel supply cylinder used must be constructed and marked in accordance with
specifications for propane cylinders of the U.S. Department of Transportation (DOT)
CFR 49, or CAN/CSA B339. The appliances is to be used only with the 20 pound,
vertical standing vapor withdrawal type tank.
• Do not store tanks under or near the smoker.
• Never fill tanks more than 80% full.
If the two previous statements above are not followed exactly, a fire causing death or
serious injury may occur.
• This smoker is designed to operate on LP (Liquefied Propane) gas only.
• DO NOT leave the smoker unattended while in use. Operate the smoker with close
supervision.
• The 20 lb LP cylinder used with this smoker must conform to the following
requirements.
Diameter- 12" (30.5cm)
Height- 18" (45.7cm)
• With a maximum capacity of 20 pounds. The gas cylinder used must include a collar to
protect the cylinder valve. The cylinder supply system must be arranged for vapor
withdrawal.
• The instructions stated on gas cylinder tanks have to be followed when filling or
transporting tanks. Failure to do so could result in problems relating to overfilling,
excessive venting release of gas and to regulator freezing.
• Do not allow dirt or foreign material to get into or onto tank connection when it is not
attached to the fuel supply system. Place the dust cap on cylinder valve outlet
whenever the cylinder is not in use. Only install the type of dust cap on the cylinder
valve outlet that is provided with the cylinder valve. Other types of caps or plugs may
result in leakage of propane.
• Cylinders must be filled before initial use. All handling, transport, filling and storage of
LP gas cylinders must be in accordance with NFPA 58 Storage and Handling of Liquid
Petroleum Gases, or CSAB 149.1 Natural Gas and Propane Installation Code. Cylinders
must be suitably tied down during transport. Do not place any other items on top of
cylinders at any time. Cylinders are not to be exposed to excessive temperatures or
high heat.
WARNING
6