Publicidad
Idiomas disponibles
Idiomas disponibles
1-14
Dell PowerVault 705N Rack Installation Guide
5.
Connect the power cable to the back of the system.
For details, see your system's Troubleshooting Guide and the User's Guide.
6.
Secure the cables to the cable-management arm:
a.
After connecting the cables to the system, unscrew the thumbscrews that
secure the front of the system to the front vertical rail.
b.
Slide the system forward to the fully extended position.
c.
Route the cables along the cable-management arm, allowing some additional
cable slack at the hinge positions, and secure the cables to the cable-
management arm with the Velcro straps attached to the cable-management
arm.
7.
Slide the system in and out of the rack to verify that the cables are routed
correctly and do not bind, stretch, or pinch with the movement of the
cable-management arm.
NOTE: As you pull the system out to its furthest extension, the slide assemblies
will lock in the extended position. To push the system back into the rack, press
the locking latch on the side of the slide to release the locks, and then slide the
system completely into the rack.
5HSODFLQJ WKH 5DFN 'RRUV
The following subsections describe procedures for replacing the rack doors on the
42-U rack and the 24-U rack.
5HSODFLQJ WKH 5DFN 'RRUV RQ D 8 5DFN
&$87,21 7R SUHYHQW SHUVRQDO LQMXU\ GXH WR WKH VL]H DQG ZHLJKW RI WKH
GRRUV QHYHU DWWHPSW WR UHPRYH RU UHSODFH WKH GRRUV E\ \RXUVHOI
1.
Lift the front door into position and align the hinges with the holes in the rack as
shown in Figure 1-3.
2.
Slide the hinges into the holes in the rack until the hinge release levers lock the
hinges into position.
3.
Close the door latch by rotating the handle counterclockwise until it stops, push
in the handle until it locks in position, and then slide the button cover down over
the push button (see Figure 1-2).
4.
Repeat steps 1 through 3 to install the back door.
Publicidad
