Hints And Tips - Kalorik EKP 43255 Manual De Instrucciones

Fax +1 305 430 9692

USE
 Select a suitable position close to an electric socket, on a dry,
flat, level, and heat-resistant surface.
 Make sure the temperature dial (4) is in the "0" position, and the
power dial (1) is in the "OFF" position, before plugging in the
power outlet.
 Plug into a 120 Volt A.C. wall outlet.
 For maximum heat efficiency, always use flat-bottomed
cookware, which makes full contact with the cooking plates.
Ideally, the pan's base should be of the same size as the cooking
plate that it is placed on.
IMPORTANT! Do not place food directly on the heating plates!
 Place filled cookware on the burner. NOTE: DO NOT operate the
burner without filled cookware on the burner.
 Turn the ON/OFF knob to the ON position by turning clockwise.
 Turn the Temperature Control Knob clockwise to the desired
setting. NOTE: "5" is the highest setting. The indicator light (3) will
illuminate at first, then blink on and off as the temperature is
reached and regulated by the thermostat.
CAUTION! The metal surface will become hot! Do not touch while in
use.
 After use, turn temperature dial back to "0", turn the power dial
back to "OFF", and unplug the appliance from the electrical
outlet. Allow the unit to cool before moving or cleaning.
 Due to the cooking plate construction, residual heat will remain
after switching off. This may be used to keep food warm for a
short period. Be careful not to touch the heating elements until
they have completely cooled down, at least for 1 hour.

HINTS AND TIPS

 Do not use with unstable pans or pans that do not have a flat
bottom.
 Never switch the unit on without a pan being placed on the
heating elements, as it may damage the appliance.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
5
Assembly page 5/24
special instruction from
Print only
EKP 43255 - 120501
Team