Chauvet BEAMshot Guía De Referencia Rápida página 4

BEAMshot™ QRG
AC Power
Power Linking
Fuse
Replacement
Mounting
Mounting
Diagram
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 62 BEAMshot™ products at 120 VAC and 100 units at
230 VAC.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Before mounting this product, read the Safety Notes.
Mounting Clamp
Bracket
Adjustment
Knobs
4
EN
Safety Cable
Hanging/Mounting
Bracket